This article will present a generic guide to configuring such a setup that should be applicable to whatever particular interface or converter you might have.Then, connect the digital cables that you are planning on using with the second interface.If you only are looking for more inputs, then you only need to connect from the ADAT output of the third party device to the ADAT input of the Apollo.Within a Thunderbolt multi-Apollo setup, the Monitor units clock signal is distributed through the host computer over Thunderbolt to the other Apollos.
This internal clocking all happens behind the scenes, so all you need to remember is to use the Word Clock Out on the Monitor Apollo unit to send the clock signal to other external equipment (such as a second interface). The Apollo Firewire and Apollo 8 offer simultaneous usage of the SPDIF ports and ADAT ports. SPDIF and ADAT cannot be used simultaneously on an Apollo 8p. In our example, connect the BNC cable from the Word Clock output of the Apollo to the Word Clock input of the secondary interface (if available). However, daisy chaining Word Clock through multiple devices is not recommended so if you are looking into setting up a more complex system with more than 2 non-Apollo devices, you will either need to purchase a dedicated external clock device that will distribute Word Clock to all of your devices, or use a BNC T-connector to split the Word Clock output from your master unit to multiple slave devices. Next, click the CLOCK field and set it to INTERNAL to use the Apollo as the master clock. For our purposes we will only have the DAW communicate with our driver - dont select the other interface, and dont create any Aggregate Devices. Snip spotify for macThe other interfaces signal will be seen coming in on the ADAT andor SPDIF channels of the Apollo. The details will vary based on the make and manufacturer of your device, but the general principles discussed here will apply regardless. If using a secondary device that functions as an audio interface on its own, this is typically done by connecting the interface to your computer temporarily and using the interfaces control software. Ableton Record External Audio Effect Apollo How To Set ThisAgain, the details on how to set this up will vary based on the device itself, but the overall idea here is to confirm that the analog input signals are being routed directly out to the digital outputs (ADAT or SPDIF). This article covers how to configure this kind of setup with Pro Tools. Super-clock, overclocking, and subclocking are not supported.
0 Comments
Leave a Reply. |
AuthorDustin ArchivesCategories |